Question

1.10K viewsOctober 12, 2020

Andy18 October 5, 2020 1 Comment

I gave it access and everything, but all I ever see is this:

View post on imgur.com

admin Changed status to publish October 12, 2020

Andy commented October 6, 2020

Small update, the program will proceed to let you select a controller if you grant it “input monitoring” permissions in “system preferences” -> “security”, however, it presents me with two separate controllers and, no matter which one I select the program will beachball and do nothing. 🙁

1 Answer

Small update, the program will proceed to let you select a controller if you grant it “input monitoring” permissions in “system preferences” -> “security”, however, it presents me with two separate controllers and, no matter which one I select the program will beachball and do nothing. 🙁

Answer 1 · 2020-10-05T21:25:36+00:00

That’s because these keyboards run QMK firmware not xwhatsit – kindly note that the switch was noted in the manual Andy 🙂

https://www.modelfkeyboards.com/manual/

I recommend everyone goes through the manual beginning to end 🙂

If you flash xwhatsit firmware, the utility will run on mac if you follow the notes in the manual. But I recommend everyone stays with QMK firmware running on their xwhatsit controller hardware.